Table of Contents
Advertisement
Top of form
When you turn on printer power, the top-of-form position is automatically
set to the current position. If this is not where you want the top of the page
to be, you can change the top-of-form position as follows.
1. Press the(
ON LINE
)button to set the printer off-line.
2. Move the paper to the desired top-of-form position by pressing the
(PAPER FEED)
button, orby performing a forward or reverse micro-feed.
3. Press and hold the (
ON LINE
1 button.
4. Press and hold the (PITCH) button.
5. Release both buttons at the same time. The printer will beep to indicate
that the top-of-form position has been set.
Forward micro-feed
For fine alignment, you can feed the paper forward in very small increments
as follows:
1. Press the (
ON LINE
1 button Lo set the printer off-line.
2. Press the (
ON LINE
) button again
and
hold it down.
3. Press the
(PAPER FEED)
button. The paper will start advancing in a series
of small steps. When you want to stop, release both buttons.
Reverse micro-feed
You can also feed the paper in small increments in reverse, to return to a
higher position on the same page.
Not'e:With fanfold forms, do not try to return to a previous page. The per-
foration may catch inside the printer.
1.
Press the
C ON LINE
1 button
lo
set the printer off-line.
2.
Press the
(
ON LINE
> button again and hold it down.
3. Press the ( SF&E&CT ) button. The paper will start moving backwards
in a series of small steps. When you want to stop, release both buttons.
c
Advertisement
Table of Contents
