Table of Contents
Advertisement
If the paper park facility does not appear to be working correctly, check the
following:
Check
Possible remedy
Is the paper
release lever in
the C position?
The paper release lever must be set to the yi position
after the fanfold paper has been parked.
Has the fanfold paper been
Make sure that the POWER indicator comes on flashing
properly parked?
after the fanfold paper has been parked.
If text is being printed all on one line, or with extra blank lines, check the
following:
Check
Is the text all on the same
line?
Possible remedy
Carriage
returns
are
not
being
expanded
to
<CR> + <LF> pairs. Check the DIP switch setting and
correct.
Is text being printed
with
) Two line feeds are being printed. Either make your
extra blank lines?
software print just a carriage return or (if this is not
possible), setthe AUTOLF toOFF withtheDIPswitch
setting.
If the page length and margins are not what is expected, check the following:
1 Check
1 Possible remedv
Is the printing
starting
too
high or too low on the page?
Does
the
printer's
page
length not match the physical
page length?
Use the Micro Feed facility to adjust the print position
relative to the page.
Use the DIP switch to set up the correct page length, or
use software commands to do it.
102
Advertisement
Table of Contents
