Setting The Colour Code Of The Led Info Bar16; Switching On The Device; Checking The Charging Station - Mennekes AMTRON Start Manual

6.1.2 Setting the colour code of the LED info bar
The configuration switch 6 (S6) is used to set the colour
scheme of the LED info bar.
The luminous colour of the symbols "Operational" and
"Charging" can be adapted, for example, to requirements
typical for a country.
S6 OFF
Standard
Operational (blue)
Charging (green)
Waiting period (white)
Malfunction (red)
 See Chapter 7.2 "LED Info bar" on page 18 for more
information about displays and flash codes.

6.2 Switching on the device

To turn on the charging station, proceed as follows:
1. Make sure that all protective devices (RCCBs and CBs) in
the charging station are turned on.
2. Turn on the power supply (back-up fuses, residual
current circuit breaker or circuit breaker).
3. Check the supply voltage at the charging station for
clockwise rotating field (see Chapter 9.3 "System
monitoring" on page 24).
 The LED on the power supply unit will light.
 The corresponding symbol on the LED info bar indicates
the operational readiness of the charging station.
S6 ON
Option
Operational (green)
Charging (blue)

6.2.1 Checking the charging station

Warning
Risk of injury
Risk of injury due to damage to the charging station.
If it appears that safe operation of the charging station is
not possible:
 Put the charging station out of service.
 Determine and eliminate any faults / malfunctions.
 See Chapter 9 "Troubleshooting" on page 22.
Inspection in accordance with DIN VDE 0100 or national
regulations
Carry out an inspection of the charging station in accordance
with DIN VDE 0100 or the applicable national regulations
prior to the initial setting-up process and according to the
specified maintenance intervals.
System check
A test box is required for a systems check. The test box
simulates the communication with the vehicle.
Test boxes are available from MENNEKES.
 See Chapter 11.1 "Accesories" on page 26.
Carry out a system check with a test box before approving
the charging station for use.
 Carry out the system check according to the
documentation of the test box.
16