Default Settings - 3Com SUPERSTACK 4226T Getting Started Manual

18 C 1: I
HAPTER NTRODUCING THE

Default Settings

S S 3 S
UPER TACK WITCH
Table 5 shows the default settings for the Switch 4200 Family:
Table 5 Default Settings
Feature
Automatic IP Configuration
Port Status
Port Speed
Duplex Mode
Flow Control
Broadcast Storm Control
Virtual LANs (VLANs)
IP Multicast Filtering
Rapid Spanning Tree Protocol
Fast Start:
RMON Alarm
Smart Auto-Sensing
LACP
Quality of Service (QoS)
If you initialize a Switch unit by selecting System > Control > Initialize in
the Web interface or by entering system control initialize in
the Command Line Interface, the following settings are retained to allow
you to connect to and manage the Switch:
IP Address
■
Subnet Mask
■
Default Router
■
4200 S
ERIES
Switch 4200 Family
Enabled
Enabled
All ports are auto-negotiated
All ports are auto-negotiated
Enabled in half duplex
■
Auto-negotiated in full duplex
■
Enabled
All ports belong to the untagged Default VLAN
(VLAN 1) with 802.1Q learning operational
Filtering enabled
Enabled
Enabled on all ports
Enabled
Enabled
(10/100/1000BASE-T ports and GBIC ports only)
Enabled
All ports prioritize NBX VoIP IP.
All ports set to "best effort" for all other traffic.