Choosing The Correct Fiber Cables - 3Com SUPERSTACK 4226T Getting Started Manual

26 C 2: I
HAPTER NSTALLING THE
Choosing the correct
Fiber cables
S
WITCH
If auto-negotiation is disabled, all the Switch ports are configured as
MDIX (cross-over). If you want to make a connection to another MDIX
port, you need a cross-over cable. Many ports on workstations and
servers are configured as MDI (straight-through). If you want to make a
connection to an MDI port, you need to use a standard straight-through
cable. See Table 7.
3Com recommends that you use Category 5 twisted pair cable — the
maximum segment length for this type of cable is 100 m (328 ft).
CAUTION: If you want to install the Switch using a Category 5E or
Category 6 cable, 3Com recommends that you briefly connect the cable
to a grounded port before connecting network equipment. If you do not,
the cables Electrostatic Discharge (ESD) may damage the Switch's port.
You can create a grounded port by connecting all wires at one end of a
UTP cable to an earth ground point, and the other end to a female RJ-45
connector located, for example, on a Switch rack or patch panel. The
RJ-45 connector is now a grounded port.
Table 7 Cables required to connect the Switch 4200 Family to other devices if
auto-negotiation is disabled
Cross-over Cable
Switch to Switch
(MDIX to MDIX)
Switch to Hub
(MDIX to MDIX)
Switch to PC (NIC)
(MDIX to MDI)
Choose from the following cable options:
The 1000BASE-SX ports can be connected to multimode fiber cables
■
only.
The 1000BASE-LX and LH70 GBIC ports use multimode or
■
single-mode fiber optic cables.
For detailed information on fiber cable specifications, refer to the
SuperStack 3 Implementation Guide that accompanies your Switch.
Straight-through Cable
✓
✓
✕
✕
✕
✓