3Com SUPERSTACK 4226T Getting Started Manual page 41

Figure 12 Example top-level command line interface menu
Menu options: --------------3Com Superstack 3 Switch 4200---------------
bridge
gettingStarted
logout
physicalInterface
protocol
security
system
trafficManagement
Type ? For help
-------------------------------(1)-----------------------------------
Select menu option:
3 At the Select menu option prompt you can either:
enter the protocol ip basicConfig command. At the Enter
■
configuration method prompt enter manual. The screen
prompts you to enter IP information.
or
enter the gettingStarted command. At the Enter
■
configuration method prompt enter manual. The screen
prompts you to enter IP information.
4 Enter the IP address, subnet mask, and gateway IP address for the Switch.
The screen displays a summary of the information entered.
The initial set up of your Switch is now complete and the Switch is ready
for you to set up your chosen management method. See
Managing a Switch"
If you do not intend to use the command line interface via the console
port to manage the Switch, you can disconnect the serial cable and close
the terminal emulator software.
Manually Configuring IP Information
- Administer bridge-wide parameters
- Basic device configuration
- Logout of the Command Line Interface
- Administer physical interfaces
- Administer protocols
- Administer security
- Administer sytem-level functions
- Administer traffic management
on page 45.
41
"Methods of