Weller WR 3ME Operating Instructions Manual page 14

WR 3ME
Settings
SETBACK time OFF time
[1-99 mins] [1-999 mins]
0
0
ON
0
Time
ON
Time 0
Time Time
0 0
ON 0
0 Time
ON Time
Time 0
Time Time
1) Not in use = UP/DOWN buttons not pressed and no temperature drop > 5 °C.
2) STANDBY temperature must be below the set setpoint temperature, otherwise the SETBACK
function is inactive.
3) When a switching holder is connected, the soldering tool always remains at the set setpoint
temperature outside the holder.
The holder function is activated when the soldering tool is stowed for the first time.
Temperature performance with different settings of the SETBACK
and AUTO OFF functions
Temperature performance without switching holder
Soldering tool remains at the set soldering temperature.
Soldering tool is switched off when not in use
has elapsed.
Soldering tool is controlled down when not in use
temperature after the SETBACK time has elapsed.
2)
Soldering tool is controlled down when not in use
temperature 2) after the SETBACK time has elapsed and is switched
off after the OFF time has elapsed.
Temperature performance with switching holder
Soldering is switched off in the holder
Soldering tool is controlled down in the holder
temperature 2) .
Soldering tool is switched off in the holder
elapsed.
Soldering tool is controlled down in the holder
temperature and is switched off after the OFF time has elapsed.
2)
Soldering tool is controlled down in the holder
temperature 2) after the SETBACK time has elapsed.
Soldering tool is controlled down in the holder
temperature after the SETBACK time has elapsed and is switched
2)
off after the OFF time has elapsed.
Note Reset of STANDBY and OFF modes:
 without switching holder by pressing the UP or DOWN button.
 with switching holder by removing the soldering tool from the
holder.
1) after the OFF time
to the STANDBY
1)
1) to the STANDBY
.
3)
to the STANDBY
3)
3) after the OFF time has
to the STANDBY
3)
3) to the STANDBY
3) to the STANDBY
13-22