Page 2
The use of there are some basic steps common to all a dampener with Giant Industries, Inc. pumps pumps. The following information is to be is optional, although recommended by Giant considered as a general outline for instal- Industries, Inc.
Page 11
P200A-5100 SERIES PARTS LIST ITEM PART NO. DESCRIPTION QTY. ITEM PART NO. DESCRIPTION QTY. 08300A Crankcase, Anodized 07023 O-Ring 08301 Dipstick, Except P217-5100 08442 Wrist Pin 08480 Dipstick, P217-5100 Only 08356-0010 Oil Seal 08444A-0100 Seal Retainer, 316 S.S. 08302A Crankcase Cover, Anodized...
Page 12
REPAIR INSTRUCTION - P200A-5100 SERIES By inserting a small screw Using a needle nose pliers, With a 22mm socket wrench, remove the (3) driver between the valve remove the inlet and dis- discharge valve plugs and seat (27) and the valve...
Page 13
REPAIR INSTRUCTION - P200A-5100 SERIES Disassembly sequence of the back end of the P200A-5100 series pump. Before you begin, drain the oil from the crankcase. Remove the crankcase cover (3) and o-ring (4) from the crankcase (1). To remove the crank- shaft (13), remove the bearing cover (7) and sight glass (8).
Page 14
Replace plungers Inlet pressure too high Reduce inlet pressure High Crankcase Wrong Grade of oil Giant oil is recommended Temperature Improper amount of oil in crankcase Adjust oil level to proper amount Preventative Maintenance Check-List & Recommended Spare Parts List...
Page 15
P200A-5100 DIMENSIONS - INCHES (mm) Pump Mounting Selection Guide Bushings 07174 - 24 mm Tapered H Bushing Pulley & Sheaves 01061 - 7.75” Cast Iron - 1 gr. - AB Section 01062 - 7.75” Cast Iron - 2 gr. - AB Section Rails 01160 - Plated Steel Channel Rails (L=5.75”x W-1.0”XH=1.812”) 01161 - Plated Steel Channel Rails (L=5.75”x W-1.0”XH=2.50”)
Page 16
A Returned Goods Authorization (R.G.A.) number and completed warranty evaluation form is required prior to the return to Giant Industries of all products under warranty consid- eration. Call (419)-531-4600 or fax (419)-531-6836 to obtain an R.G.A. number.