Vexta aStep AS Series Operating Manual page 34

34
Assembling the control input/output connector
Solder the control input/output cable to the half-pitch connector (36 pins), then install the
connector cover over the half-pitch connector.
Soldering the cable to the half-pitch connector
Solder the input/output signal cable (AWG28: 0.08 mm
(36 pins).
For the pin assignments, refer to page 35.
Assembling the half-pitch connector and the connector cover
1
. Attach the supplied screws (two pieces) to the connector cover and insert the half-pitch
connector with the control input/output cable soldered to it. Adjust the cable clamp to its
correct position.
Connector cover
Half-pitch connector
Screw
2
. Attach the other connector cover and clamp both connector covers together with screws
and nuts.
2
or more) to the half-pitch connector
Connector pin
Half-pitch connector
Cable clamp
Screw (M2)
Control input/output cable
Place the spring washer outside the connector cover.
Align the washer in the depression in the connector cover.
Clamp with screws (M2.5) and hexagonal nuts.
Tightening torque: 0.5 to 0.55 N·m (70.8 to 77.9 oz-in)