Connecting The Motor - Vexta aStep AS Series Operating Manual

Connecting the motor

Standard type
Plug the connector of the motor cable or the extension cable into the driver's motor connector
(CN2).
Push the plug until it clicks to ensure a solid connection.
Motor cable
Use an optional extension cable (sold separately) to extend the distance between the motor
and driver.
Refer to page 61 of "Appendix" for the extension cable.
Electromagnetic-brake type
Plug the connector of the extension cable into the driver's motor connector (CN2).
Push the plug until it clicks to ensure connection.
Refer to page 61 of "Appendix" for the extension cable.
Motor connector
(CN2)
Motor connector
(CN2)
Connector
Extension cable
Connector
Electromagnetic-brake-type
extension cable
Note
• Have the connector plugged in
securely.
Insecure connector connection
may cause malfunction or
damage to the motor or driver.
• To disconnect the plug, pull the
plug while using the fingers to
press the latches on the plug.
• When the motor is to be
installed in a moving part,
thereby subjecting the motor
cable to repeated bending and
stretching, use an optional
flexible cable (sold separately).
Refer to page 61 of "Appendix"
for the flexible cable.
Note
Be sure to purchase and use an
optional electromagnetic-brake-
type extension cable (sold
separately) to connect an
electromagnetic-brake-type
motor to the driver.
Direct connection to the motor
cable will not operate the brake.
31