Indoor Unit Wiring - Pioneer RAB Series Installation Manual

Table 8.2: Other World Regions
Rated Current of
Appliance (A)
6

6 - 10
10 - 16
16 - 25
25- 32
32 - 45
b. Using wire strippers, strip the rubber jacket
from both ends of the signal cable to reveal
approximately 15cm (~6") of wire.
c. Strip the insulation from the ends.
d. Using a wire crimper, crimp u-lugs onto the
ends.
NOTE: When connecting the wires, strictly
follow the wiring diagram found inside the
electrical box cover.
2. Remove the electric cover of the outdoor unit.
If there is no cover on the outdoor unit, take
off the bolts from the maintenance board and
remove the protection board.
(See Fig. 8.1, 8.2)
Fig. 8.1
3. Connect the u-lugs to the terminals.
Match the wire colors/labels with the labels
on the terminal block, and firmly screw the u-lug
of each wire to its corresponding terminal.
4. Clamp down the cable using the cable clamp.
5. Insulate unused wires with electrical tape.
Keep them away from any electrical or metal
parts.
6. Reinstall the cover of the electric control box.
 
Page 24
Nominal Cross-Sectional
Area (mm²)
0.75
1
1.5
2.5
4
6
Cover
Screw

Indoor Unit Wiring

1. Prepare the cable for connection
a. Using wire strippers, strip the rubber jacket
from both ends of the signal cable to reveal
about 15cm (~6") of the wire.
b. Strip the insulation from the ends of the
wires.
c. Using a wire crimper, crimp the u-lugs onto
the ends of the wires.
2. Remove the cover of the electric control box
on your indoor unit.
3. Connect the u-lugs to the terminals.
Match the wire colors/labels with the labels
on the terminal block, and firmly screw the u-lug
of each wire to its corresponding terminal.
Refer to the serial number and wiring
diagram located on the cover of the electric
control box.
Control Box
Wiring Diagram
(if supplied and packed with the accessories)
Magnetic Ring
1 2 3
Fig. 8.4
Connective Wiring Diagram
Fig. 8.3
Pass the belt through
the hole of the Magnetic
ring to fix it onto the cable