Hardware Identification Chart - Stamina 1300 Owner's Manual

HARDWARE IDENTIFICATION CHART

This chart is provided to help identify the hardware used in the assembly process. Place the washers or the
ends of the bolts or screws on the circles to check for the correct diameter. Use the small scale to check the
length of the bolts and screws.
3/16" 1/4"
0 1/2 1
0 10 20
6
NOTICE: The length of all bolts and screws, except those with flat heads,
is measured from below the head to the end of the bolt or screw.
Flat head bolts and screws are measured from the top of the
head to the end of the bolt or screw.
After unpacking the unit, open the hardware bag and make sure that you have all the following items.
Some hardware may be already attached to the part.
5/16" 3/8"
1/2 2 1/2
30 40 50 60
8 10
Part No. and Description
40
41
42
48
49
50
52
55
56
58
1/2"
3 1/2 4
70 80 90 100 110 120 130 140 150
MILLIMETERS
12
Carriage Bolt (M8 x 1.25 x 65mm)
Bolt, Button Head (M8 x 1.25 x 15mm)
Bolt, Button Head (M8 x 1.25 x 30mm)
Screw, Round Head (M5 x 0.8 x 15mm)
Screw, Round Head (M6 x 1 x 8mm)
Nylock Nut (M8 x 1.25)
Acorn Nut (M8 x 1.25)
Arc Washer (M8)
Lock Washer (M8)
Washer (M8)
6
INCHES
1/2 5 1/2
length
length
6
in.
mm.
Qty
4
4
1
4
2
3
4
8
8
3