Instructions Guide; Basic Operation - MAJORITY EDDINGTON EDD-DAB-BLK Instruction Manual

Instructions Guide

Basic Operation

Please note all (Ref.) refer to the Page 1-2 Controls and Functions guide.
Plug the USB cable into a power source and connect into the
side of the radio, labelled "DC IN" (Ref.11) to power and charge
the radio. Alternatively, charge the radio for approximately
4 hours to charge the internal battery. This will allow for
approximately 11 hours of charge and portability.
Ensure the antenna (Ref.9) is extended as far as possible. This
will allow the radio to receive the best possible signal before
DAB or FM mode is selected.
At the side of the radio, switch the 'ON/OFF' toggle to "ON"
(Ref.10) and "MAJORITY" will display on the screen as the radio
loads.
On first set up, the radio will begin to scan for available DAB/
DAB+ stations and will display "Scanning.... " as the radio scans.
Once the scan is complete, the first available station will begin to
play. If a scan for digital stations does not occur, refer to page 6.
Press the 'Standby/Mode' button (Ref.4) repeatedly to switch
between DAB, FM and Bluetooth modes.
Standby and Lock Feature
To switch your radio to Standby mode, press and hold the
'Standby/Mode' button (Ref.4). To turn on the radio, simply press
the 'Standby/Mode' button.
You can lock the buttons of the radio for convenience on the go
by pressing and holding down the 'Lock/Menu' button (Ref.8)
for 2 seconds. "Locked" will then display. To unlock buttons,
repeat the same action and "Unlocked" will then display.
5