VESTEL F4 Series Service Manual page 4

2.1.4. Water Supply Connection
1. Washing machine is supplied with a single (cold) water
inlet.
2. To prevent leakage from the connection joints, a rubber
washer is included in the hose packing. Fit this washer
at the end of water inlet hose on the tap side.
3. Connect the hose to the water inlet valve. Tighten the
plastic connector by hand. Please call a qualified
plumber if you are unsure about this.
4. Water pressure of 0,1-1 MPa from
machine to work more efficiently.(0,1 MPa pressure
means water flow of more than 8 litres in 1 minute from
a fully opened tap)
2.1.5. Drain Connection
1. Make sure that water inlet hoses are not folded, twisted,
crushed or stretched.
2. The drain hose should be mounted at a minimum height
of 60 cm, and a maximum height of 100 cm from the
floor.
2.2. Detergent Box Group
MAIN
SOFTENER
PREWASH
PREWASH = WATER ENTRY VALVE 1
MAIN = WATER ENTRY VALVE 2
SOFTENER = WATER ENTRY VALVE 1 + VALVE 2
tap will enable
VALVE1
VALVE2
5. After connection is complete, check for leakage by
turning on tap completely.
6. Make sure that water inlet hoses can not become folded,
damaged, stretched or crushed when the washing
machine is in its final position.
Mount the water inlet hose to a ¾" threaded water tap.
7.
3. The end of the drain hose can be connected directly to a
drainage stand-pipe or alternatively to a specific
connection point designed for that purpose on the waste
outlet of a sink unit.
4. Do not extend the drain hose or
invalidated.
guarantee will be
4