Installation Instructions - VESTEL F4 Series Service Manual

2.

Installation Instructions

2.1. Moving and Installing
2.1.1. Removal of Transportation Screw
1. Transportation screws, which are located at the back
side of the machine, must be removed before running
the machine.
2. Loosen the screws by turning them anticlockwise with a
suitable spanner.
3. Pull out the screws and rubber washers.
2.1.2. Foot Adjustment
1. Do not install machine on rugs or similar surfaces.
2. For machine to work silently and without any vibration, it
should be installed on a flat, non-slippery firm surface.
Any suspended floor must be suitably strengthened.
3. You can adjust the level of machine using its feet.
4. First, loosen the plastic adjustment nut away from the
cabinet base.
2.1.3. Electrical Connection
1. Washing machine requires a 50Hz supply of 220-
240Volts.
2. A special earthed plug has been attached to the supply
cord of washing machine. This plug must be fitted to an
earthed socket. The fuse value fitted to this plug should
be 13 amps. If you have any doubts about electrical
supply, consult a qualified electrician.
Reference Number: SM2410201600F4PY
4. The holes where the transport screws have been
removed should be covered with the plastic transport
caps found in the accessories bag.
5. The transportation screws that have been removed from
the machine must be re-used in any future transporting
of the machine.
5. Change the level by adjusting the feet upwards or
downwards.
6. After level has been reached, tighten the plastic
adjustment nut again by rotating it upwards
against the base of the cabinet.
7. Never put cartons, wooden blocks or similar
materials under
irregularities of the floor.
THIS APPLIANCE MUST BE EARTHED.
Insert the machine's plug to a grounded
socket which you can easily reach.
Document without reference number is not valid.
the machine to balance