Shenchen Pump
VDC)
If need change to 24VDC or 12VDC input, please open the controller
housing, and change the jumper connection on the external control
board as below :
The signal recognition is rising edge effective, the minimum duration of the high
level is 200ms.
GD2:The common port of the external control signal input.
NC:External control full speed signal input ( full speed with high level signal, stop
with low level signal).
CW/CCW:External control direction signal input (signal rising edge effective. )
R/S 2: External control start signal input ( signal rising edge effective).
3)
R/S 1 :External control start/stop signal input port: Passive signal input
This port can be connected to a passive switch or a foot switch. Set the validity of
this input in the external control setting interface - foot switch option.
- 11 -
F Series