Stops; Installation Of The Laser; Cutting Gap Adjustment - hawa Quick-press 400 Instruction Manual

Quick-press 400 Instruction Manual

5.6 Stops

• Are mounted on the guide profile of the stop bar (2 pieces).
• By pressing back the stop lever on the measuring unit, the respective measure can be read and set.

5.7 Installation of the laser

• The laser is factory set.
• The laser beam can be adjusted by 3 screws in the laser housing if necessary.

5.8 Cutting gap adjustment

• Set required cutting gap, before every single initial punch.
• When the form tool is in place, stamp template.
Cutting gap adjustment:
• Loosen the screws in the die housing.(see part list item2)
• Adjust the die to desired cut gap size.
• Refasten mounting screws, and re-check cutting gap.
6. Operating instructions
Tool pre-fastening:
Convenient and quick change of die possible by pulling out the safety pin (about 3 mm).
Pressure is supplied through a threaded pin.
Footswitches:
Pressing the left pedal of the footswitch the hydraulic cylinder is switched operational.
Releasing the footswitch stalls the device in its released position.
Pressing the right pedal of the footswitch releases the device to its starting position.
Height adjustment:
By pulling the locking pin, the guide bar can be adjusted in height.
Depth adjustment:
By loosening the clamp lever, the depth of the stop bar can be adjusted smoothly.
Cutting gap
13