Using Flash; Using Tone Services Ona Pulse Line; Using Page/Intercom - Sprint 2.4 GHz Digital Spread Spectrum Dual Keypad Cordless Phone with Caller ID/Call Waiting Owner's Manual

43-5522.fm Page 15 Tuesday, September 12, 2000 3:12 PM
• On the handset, press
pressing to dial the last number
TALK
dialed.
• The redial memory holds up to 32 digits,
so you can redial long-distance as well
as local numbers.
• The redial memory also holds pause
entries. See "Entering a Pause" on
Page 17.

USING FLASH

performs the electronic equivalent of
FLASH
a switchhook operation for special services,
such as Call Waiting.
For example, if you have Call Waiting, press
to answer an incoming call without
FLASH
disconnecting the current call. Press
again to return to the first call.
Note: If you do not have any special phone
services, pressing FLASH
the current call.
USING TONE SERVICES ON
A PULSE LINE
Some special services, such as bank-by-
phone, require tone signals. If you have
pulse service, you can still use these special
tone services by following these steps.
1. Be sure
PULSE-TONE
2. Dial the service's main number.
3. When the service answers, press
. Any additional numbers you dial
TONE
are sent as tone signals.
When you hang up, the phone automatically
resets to pulse dialing.

USING PAGE/INTERCOM

after
RDL/PAUSE
You can use the phone as a two-way pager
and intercom between the base and the
handset. This is useful if the handset is away
from the base and you want to locate it, or if
you want to have a conversation between
someone with the handset and someone at
the base.
To page the base from the handset, press
TCM/DEL
base and handset ring. Press
INTCM/PAGE
page.
To page the handset from the base, press
TCM/PAGE
Paging
on the handset to answer the page.
com
FLASH
To end an intercom call, press
handset, press
might disconnect hang up the handset.
If a call comes in during an intercom conver-
sation, either the person at the base or the
person at the handset can answer the call.
Press
the base once to end the intercom call, then
press
incoming call.
Note:
party being paged is already on a call.
is set to .
PULSE
Transferring a Call between the
Handset and Base
/
You can use the phone's intercom feature to
transfer a call between the handset and the
base.
To transfer a call from the handset to the
base, press
hold, and
Telephone Operation
. Paging Base appears, and the
on the base to answer the
Intercom appears.
. The handset and base ring, and
appears. Press
TALK
appears.
on the base, or
SPEAKER
TALK on the handset or
or again to answer the
TALK SPEAKER
The intercom does not operate if the
. The call is placed on
INTCM/DEL
and
Paging Base
IN-
or
SPEAKER
IN-
or
INTCM/DEL
Inter-
on the
TALK
SPEAKER on
appear.
Hold
15