Setting The Dialing Mode; Setting The Ringer Tone/Volume; Turning Auto Talk On/Off; Turning Caller Id/Call Waiting On/Off - Sprint 2.4 GHz Digital Spread Spectrum Dual Keypad Cordless Phone with Caller ID/Call Waiting Owner's Manual

43-5522.fm Page 12 Tuesday, September 12, 2000 3:12 PM
SETTING THE DIALING
MODE
Set on the back of the base for
PULSE-TONE
the type of service you have. If you are not
sure which type you have, do this test after
you charge the handset's battery pack.
1. Set to
PULSE-TONE
2. Lift the handset and press
press Listen for a dial tone.
SPEAKER.
3. Press any number other than 0.
Note: If your phone system requires that
you dial an access code (9, for example)
before you dial an outside number, do
not press the access code, either.
If the dial tone stops , you have touch-
tone service. Leave
.
TONE
If the dial tone continues , you have
pulse service. Set
.
PULSE
4. Press or place the handset on the
TALK
base to hang up.
SETTING THE RINGER
TONE/VOLUME
You can select one of four different ringer
tone/volume settings on the handset. Re-
peatedly press
VOL/CID
during a call) to select the desired ringer set-
ting. Each time you press a button, the
phone rings at the selected setting and
,
Ringer A High Ringer A Low
er B High , or Ringer B Low
Note: Pressing
VOL/CID
9 9 9 9
High or at
VOL/CID
does not change the setting. Press the oppo-
site arrow key to change the setting.
12
.
TONE
, or
TALK
set to
PULSE-TONE
set to
PULSE-TONE
8 8 8 8 9 9 9 9
or (except
,
Ring-
appears.
8 8 8 8
at
Ringer A
Ringer B Low
Installation
To set the base's ringer volume, set
on the back of the base to
VOL
.
HI
Note: When you set
RING VOL
base (and the handset if it is on the base)
does not ring but other phones connected to
the same phone line rings. If the handset is
away from the base, it also rings.
TURNING AUTO TALK ON/
OFF
Your phone is preset so you must press
when you lift the handset from the base
TALK
to answer a call. With auto talk turned on,
you can answer a call by just lifting the hand-
set from the base. If the handset is away
from the base, you can answer by pressing
any key.
Follow these steps to turn auto talk on or off.
1. Lift the handset and hold down
menu appears with
selected.
2. Press
SELECT/CHANNEL
auto talk setting. On
3. Return the handset to the base or press
to store the new setting.
CID
Note: When auto talk is set to off, the hand-
set continues to ring after you lift the handset
from the base until you press
TURNING CALLER ID/CALL
WAITING ON/OFF
If you subscribe to Call Waiting with Caller ID
service, you can set the phone to show Call-
er ID information for an incoming call even
while you are using the phone.
Follow these steps to turn the Caller ID/Call
Waiting feature on or off.
1. Lift the handset and hold down
RING
, , or
OFF LO
to , the
OFF
. A
CID
Auto Talk
to change the
or Off appears.
.
TALK
.
CID