Do you have a question about the 2.4 GHz Digital Spread Spectrum Dual Keypad Cordless Phone with Caller ID/Call Waiting and is the answer not in the manual?
Questions and answers
Related Manuals for Sprint 2.4 GHz Digital Spread Spectrum Dual Keypad Cordless Phone with Caller ID/Call Waiting
43-5522.fm Page 2 Tuesday, September 12, 2000 3:12 PM ˆ Contents Features ... 6 Installation ... 8 Mounting the Phone ... 8 Connecting, Charging and Replacing the Battery Pack ... 9 A Quick Look at the Handset ... 11 Setting the Dialing Mode ... 12 Setting the Ringer Tone/Volume ...
43-5522.fm Page 3 Tuesday, September 12, 2000 3:12 PM This phone has been tested and found to comply with all applicable UL and FCC stan- dards. WARNING: To reduce the risk of fire or shock hazard, do not expose this product to rain or moisture.
43-5522.fm Page 4 Tuesday, September 12, 2000 3:12 PM • Some cordless phones operate at fre- quencies that might cause interference to nearby TVs and VCRs. To minimize or prevent such interference, the base of the cordless phone should not be placed near or on top of a TV or VCR.
43-5522.fm Page 5 Tuesday, September 12, 2000 3:12 PM IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, ba- sic safety precautions should always be fol- lowed to reduce the risk of fire, electric shock and injury to persons, including the following: 1.
43-5522.fm Page 6 Tuesday, September 12, 2000 3:12 PM • If liquid has been spilled into the prod- uct. • If the product has been exposed to rain or water. • If the product does not operate normally by following the operating instructions. Adjust only those controls that are cov- ered by the operating instructions because improper adjustment of other...
Page 7
43-5522.fm Page 7 Tuesday, September 12, 2000 3:12 PM Your phone has these features: 2.4 GHz Operation — provides longer range and less interference than many other cord- less phones. Spread Spectrum Technology — spreads the signal across several frequencies for added security during phone conversations.
43-5522.fm Page 8 Tuesday, September 12, 2000 3:12 PM ˆ Installation MOUNTING THE PHONE You can place the phone on a desk or table, or mount it on a standard wall plate or direct- ly on a wall. Select a location that is: •...
43-5522.fm Page 9 Tuesday, September 12, 2000 3:12 PM On a Wall Plate or Wall 1. Insert the bracket’s tabs into the base’s lower tab slots, then press down on the bracket’s clips and insert them into the clip slots. 2.
Page 10
43-5522.fm Page 10 Tuesday, September 12, 2000 3:12 PM 1. Press down and slide off the battery pack compartment cover. 2. Lift the battery pack out of the compart- ment. 3. Plug the bat- tery pack's con- nector into the socket compartment, (the connector...
43-5522.fm Page 11 Tuesday, September 12, 2000 3:12 PM Important: The EPA certified ® RBRC Battery Recycling Seal on the nickel-cadmium (Ni-Cd) battery indicates RadioShack is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada.
43-5522.fm Page 12 Tuesday, September 12, 2000 3:12 PM SETTING THE DIALING MODE on the back of the base for PULSE-TONE the type of service you have. If you are not sure which type you have, do this test after you charge the handset's battery pack.
43-5522.fm Page 13 Tuesday, September 12, 2000 3:12 PM 9 9 9 9 2. Press to select VOL/CID (Caller ID/Call Waiting). 3. Press to change the SELECT/CHANNEL Caller ID/Call Waiting setting. appears. 4. Return the handset to the base to store the new setting.
43-5522.fm Page 14 Tuesday, September 12, 2000 3:12 PM SELECTING THE CHANNEL The phone has 30 channels. If the call seems to disconnect for no reason during a call, press on the handset SELECT/CHANNEL to select a different channel. Scanning pears while your phone searches for a clear channel.
43-5522.fm Page 15 Tuesday, September 12, 2000 3:12 PM • On the handset, press RDL/PAUSE pressing to dial the last number TALK dialed. • The redial memory holds up to 32 digits, so you can redial long-distance as well as local numbers. •...
43-5522.fm Page 16 Tuesday, September 12, 2000 3:12 PM When the person at the base answers, press . The call is released from hold and TALK transferred to the base. To transfer a call from the base to the hand- set, press INTCM/PAGE .
Page 17
43-5522.fm Page 17 Tuesday, September 12, 2000 3:12 PM To replace a stored number, store a new one in its place. Editing or Deleting a Number in the Handset’s Memory Follow these steps to edit or delete a memo- ry number. 1.
43-5522.fm Page 18 Tuesday, September 12, 2000 3:12 PM Reviewing the Handset's Memory Numbers To review your handset's memory numbers, press . The list of memory location num- bers ( – ) appears with the name stored with each number (or <Memory nn>...
43-5522.fm Page 19 Tuesday, September 12, 2000 3:12 PM • You can use a handset holder (available from your local RadioShack store) to hang the handset on your belt for greater convenience. ˆ Caller ID Operation If you subscribe to Caller ID service from your phone company, the phone company sends information about the call, as well as the time and date, between the first and sec-...
43-5522.fm Page 20 Tuesday, September 12, 2000 3:12 PM Display Description The caller is not within a Unknown Caller ID service area. Name Unknown Number Appears if there was an Incomplete error during the transmis- Data sion of Caller ID informa- tion.
43-5522.fm Page 21 Tuesday, September 12, 2000 3:12 PM 3. Press SELECT/CHANNEL The phone beeps once. Follow these steps to delete all Caller ID records. 1. Press so the record totals appear. 2. Press Delete All? INTCM/DEL appear with the cursor pointing Yes/No 8 8 8 8 3.
43-5522.fm Page 22 Tuesday, September 12, 2000 3:12 PM 4. Press . The selected service num- TALK ber appears and is dialed. Note: You can display the programmed ser- vice number of each calling feature. At Step 7 7 7 7 2 above, press to view the number and to return to the name display.
43-5522.fm Page 23 Tuesday, September 12, 2000 3:12 PM Problem The handset stops working or Move the handset closer to the base. works poorly during a call. Lift the base's antenna to a fully vertical position. Be sure the handset's battery pack is charged. (If the battery pack power is too low, the handset cannot display Low volume or unusual Someone has picked up another phone on the same line.
Page 24
43-5522.fm Page 24 Tuesday, September 12, 2000 3:12 PM • Handle the phone gently and carefully. Do not drop it. • Keep the phone away from dust and dirt. • Wipe the phone with a damp cloth occasionally to keep it looking new. Modifying or tampering with the phone’s internal components can cause a malfunction and might invalidate its warranty and void your FCC authorization to operate it.
Need help?
Do you have a question about the 2.4 GHz Digital Spread Spectrum Dual Keypad Cordless Phone with Caller ID/Call Waiting and is the answer not in the manual?
Questions and answers