Installed Turbotwister Structural & Installation Checklist; Daily/Weekly Maintenance Of The Turbotwister; Cleaning Instructions - S.R.Smith TURBOTWISTER Owner's Manual

INSTALLED TURBOTWISTER STRUCTURAL & INSTALLATION CHECKLIST
After installation and prior to the first use of Turbotwister and periodically (see DAILY/WEEKLY
MAINTENANCE) thereafter the owner must:
1. Inspect the runway for visible cracks or tears.
3. Inspect the ladder for sharp edges, protrusions, cracks or tears.
4. Inspect ladder and pedestal mounting areas for loose or corroded fasteners.
5. Measure the following dimensions and compare with the manufacturer's placement instructions
on pages 7 and 8.
• Pool water depth at the base of the slide should be at least 3' (914 mm) deep, and at 4'6"
(1372 mm) out from slide exit, should be at least 4'6" (1372 mm) deep.
• The height of the slide runway exit above the water should be 20" (508 mm) maximum.
• The distance between the slide centerline and the edge of other pool equipment should
be at least 3'6" (1067 mm).
6. Observe the position of the exit of the slide as shown in FIGURE B, FIGURE C, and FIGURE E
on pages 7 and 8.
Read, understand and enforce all safety and use instructions on the slide.
7.

DAILY/WEEKLY MAINTENANCE OF THE TURBOTWISTER

1. When hosing down the deck, hose your Turbotwister to wash away any dust, dirt or other debris,
which may have accumulated.
2. Be sure that all connections are secure. Tighten hardware if necessary.
3. All polyethylene parts require little maintenance. Hose and wipe to clean.
While cleaning slide, check and see that all nuts and bolts are tight and secure.
4. Inspect the runway for visible cracks or tears, sharp edges and protrusions.
5. Inspect all attachment points for loose or corroded fasteners.
6. Inspect all ladder tread or step-attachment points for evidence of shear, bending yield, or fatigue
in the ladder steps, rails, or attachments means. Yield is evidenced by crystallization or fine
cracking of the ladder tread and/or surface.
Inspect the ladder handrails for rigidity and attachment.
7.
Use nonabrasive soap and water when possible. In addition, you may safely use the products listed
below. Always try a test spot before applying to a large area.
Windex ® With Ammonia
Soft Scrub ®
Glass Plus ®
Always read the label instructions on any cleaner carefully before applying it to a polyethylene surface.
AVOID HARSH CHEMICALS AND DISINFECTANTS. DO NOT USE:
Dow with Scrubbing Bubbles ® Lysol ® Disinfectant
Windex ® With Vinegar

CLEANING INSTRUCTIONS

Formula 409 ®
Scrubfree
Topjob ®
White Cap ®
5
Fantastik ®
Tackle ®
Tilex ®
Ajax ® Cleanser
Ajax ® Liquid