Table of Contents
Advertisement
SLIDE. PERSONS WITH PHYSICAL DISABILITIES SHOULD USE CAUTION
AND MAY REQUIRE ASSISTANCE.
14. DO NOT USE THE SLIDE IF ANY PART OF IT BECOMES DAMAGED,
WEAKENED, OR BROKEN. HAVE THE SLIDE INSPECTED AND, IF
NECESSARY, REPAIRED BY A POOL PROFESSIONAL, WHO IS FAMILIAR
WITH WATER SLIDES BEFORE USING THE SLIDE. SEE
STRUCTURAL & INSTALLATION CHECKLIST
Slide users must use the sitting slide position, facing forward, feet first as shown in
Figure 1.
INSTALLED VORTEX STRUCTURAL & INSTALLATION CHECKLIST
After installation and prior to the first use of the VORTEX and periodically (see
DAILY/WEEKLY MAINTENANCE OF THE VORTEX) thereafter the owner must:
1. Inspect the runway for visible cracks or tears.
2. Inspect the ladder for sharp edges, protrusions, cracks or tears.
3. Inspect ladder and pedestal mounting areas for loose or corroded fasteners.
4. Measure the following dimensions and compare with the Manufacturer's
Placement Instructions on pages 6 AND 7.
Measure the depth of water in front of the slide exit. (4-6") min. depth at a
distance of (4-6") from exit end of slide.
Measure the height of the slide runway exit above the water. (20" max.)
Measure the distance between the slide centerline and the edge of other
pool equipment.
5. Observe the position of the exit of the slide as shown in Figures 2, 3 and 5 on
pages 6 and 7.
6. Read, understand and enforce all safety and use instructions on the slide.
DAILY/WEEKLY MAINTENANCE OF THE VORTEX
1. Periodically inspect the Vortex to assure there are no worn parts and that all
hardware is properly tightened. Replace any hardware which exhibits rust or
corrosion.
.
PROPER SLIDING POSITION
FIGURE 1
4
INSTALLED SLIDES'
Advertisement
Table of Contents
