Summary of Contents for Smith & Noble Metro Track Flat Aluminum Hardware
Page 1
STEP BY STEP INSTALLATION INSTRUCTIONS Metro Track Flat Aluminum Hardware Warranty Service The enjoyment of your hardware should be everlasting, which is why our products come with a limited lifetime warranty. The warranty applies to the original owner, requires a proof of purchase (hang on to your receipt!) and covers defects in material or craftsmanship.
STEP 1 - GETTING STARTED OVERVIEW Getting Started Ceiling Mount Bay Single Rod Set Before you begin, check the accompanying diagram to make sure you have all the parts you need. You’ll need to make sure the surface you intend to install your hardware is sturdy enough to accommodate the brackets.
STEP 2 - MARKING BRACKET PLACEMENT STEP 3 - ATTACHING THE ROD CONNECTOR Mounting the Brackets 2" CLEARANCE FROM WALL Place the panel on one of the OR WINDOW rods. Hold it up to the spot you Depending on your order, you may have ROD CONNECTOR wish to install it making sure there received a rod connector.
STEP 5 - ATTACHING BRACKET TO THE POSTS STEP 4 - PLACING CARRIERS & END STOPS Adding or Removing Carriers to the Rod CEILING CHANNELS Insert the ceiling brackets into the BRACKET channel in the back of the rod. Do not Your track rods will come with all master tighten at this time.
STEP 6 - ATTACHING FINIALS STEP 7 - ATTACHING ELBOW BRACKET ° Corner or Elbow Bracket Elbow END CAP FINIALS 90° Corner Bracket Slide in End Cap onto rod and tighten Slide in 90° corner bracket or elbow set screw. onto the end of the left rod where there SET SCREW is no finial end cap and tighten set screw.
STEP 8 - ATTACHING BRACKET TO CEILING STEP 9 - ATTACHING DRAPERY TO ROD Insert drapery pin hooks into carriers STEP 1: Hold the left rod up and attach the and master carriers. bracket to the ceiling, aligning the holes Split Drapery of the bracket with the marks you made MASTER...
ACCESSORIES CARE & CLEANING Baton/Wand (optional) Minimal care and cleaning is needed to maintain the beauty of your Hardware. Baton/Wand will be pre-attached to the CLIP To Vacuum: Use brush or dust head attachment. master carrier(s). To Dust: Use soft, clean cloth. MASTER CARRIER BATON/...
Need help?
Do you have a question about the Metro Track Flat Aluminum Hardware and is the answer not in the manual?
Questions and answers