Smith & Noble Metro Track Flat Wood Hardware Installation Instructions Manual

Ceiling mount single rod set
Hide thumbs Also See for Metro Track Flat Wood Hardware:

Advertisement

Quick Links

Warranty Service
The enjoyment of your hardware should be everlasting, which is why our
products come with a limited lifetime warranty. The warranty applies to the
original owner, requires a proof of purchase (hang on to your receipt!) and
covers defects in material or craftsmanship. Hardware must have been properly
installed. We reserve the right to determine if your hardware warrants a repair
or a replacement. Visit smithandnoble.com/guarantee to see full details. In
need of warranty service? Call us at 800.248.8888 and we'll arrange for a repair
or replacement ASAP.
© 2019 Smith & Noble Home, Inc. All Rights Reserved
STEP BY STEP INSTALLATION INSTRUCTIONS
Metro Track
Flat Wood
Hardware
SN0519
Ceiling Mount
Single Rod Set

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Metro Track Flat Wood Hardware and is the answer not in the manual?

Questions and answers

Summary of Contents for Smith & Noble Metro Track Flat Wood Hardware

  • Page 1 STEP BY STEP INSTALLATION INSTRUCTIONS Metro Track Flat Wood Hardware Warranty Service The enjoyment of your hardware should be everlasting, which is why our products come with a limited lifetime warranty. The warranty applies to the original owner, requires a proof of purchase (hang on to your receipt!) and covers defects in material or craftsmanship.
  • Page 2 Everything Table of Contents You Need Getting Started ........3 Step 1 - Ceiling Mount Single Rod Set .
  • Page 3 STEP 1 - GETTING STARTED OVERVIEW Tools & Parts Ceiling Mount Single Rod Set Before you begin, check the accompanying diagram to make sure you have all the parts you need. You’ll need to make sure the surface you intend to install your hardware is sturdy enough to accommodate the brackets.
  • Page 4 STEP 2 - MARKING BRACKET PLACEMENT STEP 3 - ATTACHING THE ROD CONNECTOR Mounting the Brackets Depending on your order, you may have received a rod connector. Place the panel on the rod. Hold it up to the spot you wish to install it A rod connector is the short piece of making sure there is enough spac- ROD CONNECTOR...
  • Page 5 STEP 4 - ADDING OR REMOVING CARRIERS STEP 5 - ATTACHING THE BRACKET TO THE ROD Adding or Removing Carriers to the Rod CEILING CHANNEL Insert the ceiling brackets into the BRACKET channel in the back of the track. CARRIERS Your track rod will come with all master Do not tighten at this time.
  • Page 6 STEP 6 - ATTACHING THE FINIALS STEP 7 - ATTACHING BRACKETS TO THE CEILING Slide in End Cap onto rod and tighten END CAP FINIALS Hold the rod up and attach the bracket to set screw. the ceiling, aligning the holes of the brack- et with the marks you made on ceiling on End Cap can be attached with the a previous step.
  • Page 7 STEP 8 - ATTACHING DRAPERY TO ROD ACCESSORIES Baton/Wand (optional) Insert drapery pin hooks into carriers Baton/Wand will be pre-attached to CLIP and master carriers. the master carrier(s). Split Drapery MASTER DRAPERY For Split drapery, start pining from CARRIER PINS CARRIERS the center and go towards the ends.
  • Page 8 CARE & CLEANING NOTES Minimal care and cleaning is needed to maintain the beauty of your Hardware. To Vacuum: Use brush or dust head attachment. To Dust: Use soft, clean cloth. smithandnoble.com 800.248.8888...

Table of Contents