AMP Lighting VAC-ZWM1-BBZ Installation & Maintenance Manual

Low voltage landscape lighting built-in hub base with stake mount

Advertisement

Quick Links

INSTALLATION & MAINTENANCE GUIDE
AMP
Low Voltage Landscape Lighting
®
AMP
Built-In Hub Base with Stake Mount
®
VAC-ZWM1-BBZ
Help Hotline:
1-813-978-3900 • Mon-Fri 9am-6pm (EST)
w w w. a m p l i g h t i n g . c o m

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VAC-ZWM1-BBZ and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for AMP Lighting VAC-ZWM1-BBZ

  • Page 1 INSTALLATION & MAINTENANCE GUIDE Low Voltage Landscape Lighting ® Built-In Hub Base with Stake Mount ® VAC-ZWM1-BBZ Help Hotline: 1-813-978-3900 • Mon-Fri 9am-6pm (EST) w w w. a m p l i g h t i n g . c o m...
  • Page 2: Important Safety Instructions

    INSTALLATION & MAINTENANCE GUIDE Built-In Hub Base with Stake Mount ® VAC-ZWM1-BBZ Important Safety Instructions: Read Before Installation This luminaire is intended for installation in accordance with local codes and the National Electric Code (NEC). Failure to adhere to these codes and instructions may result in serious injury, property damage and void the warranty.
  • Page 3 Main low voltage cable Main low voltage cable shall be sized as one of the following: A. Underground low energy circuit cable B. SPT-3 or SPT-2W C. Any junior hard service cord specified in 24.3.1.2 D. Any other wire rated as sunlight resistant, suitable for wet locations, and intended for direct burial as defined in the Standard for Thermoplastic-Insulat- ed Underground Feeder and Branch-Circuit Cables, UL 493.
  • Page 4 INSTALLATION & MAINTENANCE GUIDE Built-In Hub Base with Stake Mount ® VAC-ZWM1-BBZ Install Fixture to Built-In Hub Top Pass the supply wires from the fixture through the built-in hub top. Thread Fixture the fixture onto the built-in hub top and hand tighten until snug.
  • Page 5 INSTALLATION & MAINTENANCE GUIDE Built-In Hub Base with Stake Mount ® VAC-ZWM1-BBZ Install Stake Determine the desired location Board for mounting the stake mount. Hammer the stake into the ground until flange of stake is flush to grade. To avoid damage to the stake, place a board on top of the stake while hammering.
  • Page 6 INSTALLATION & MAINTENANCE GUIDE Built-In Hub Base with Stake Mount ® VAC-ZWM1-BBZ w w w. a m p l i g h t i n g . c o m –6– –6–...
  • Page 7 customersupport@amplighting.com • 813.978.3900 –7–...
  • Page 8 Help Hotline: 1-813-978-3900 • Mon-Fri 9am-6pm (EST) Specifications and product details subject to change without notice. © Copyright 2019, AMP Lighting, Lutz FL USA 33549 • All rights reserved. ® customersupport@amplighting.com • 813.978.3900 w w w. a m p l i g h t i n g . c o m IS-VAC-ZWM1A-BBZ-ver1.pdf...

This manual is also suitable for:

Vac-zwm2-bbzVac-zwm3-bbz

Table of Contents