Installation Procedure - Toto Renesse TL170SD Owner's Manual

Single handle lavatory faucet

Hide thumbs Also See for Renesse TL170SD:

Installation and owner's manual (16 pages)

Table of Contents

Available languages

IM PORTANT: Before installation, any

dirt and debris in the cold/hot water

supply pipes must be washed out.

1) Wipe any dirt away from around the

installation hole.

Measure the installation holes and

select the gasket that will fit the hole

diameter:

Hole more than

1-7/16" (36mm)

Winged Gasket

2) Place the correct gasket around both supply hoses and move it up against the bot-

tom surface of the faucet body. Insert the hoses into the mounting hole until the

spout rests on the surface.

3) Place the mounting flange on the shaft of the faucet as shown. Place the flat washer

and lock washer onto the shaft and fasten the nut until it is snug. Double-check the

faucet alignment and tighten the nut to secure it.

4) Insert one gasket in each connector and

fasten to each of the supply stop valves. Use

a wrench to tighten them.

5) Place one gasket in each cap nut of the cold/

hot flex hoses and fasten to each of the con-

nectors. Use a wrench to fasten them.

WARNINGS:

• The minimum bending radius of the hose is

2-3/8" (60mm). Bending it further may cause

damage.

• During installation, do not bend the hose

from the end surface of the main faucet body

too far.

• Do not pull the hose violently as this may

break the hose.

• Avoid unnecessary contact of similar hoses, as

friction may cause damage.

R=2-3/8" (60mm)

Hot Water

Supply Hose

R=2-3/8"

(60mm) and

higher

Good