Pentair Pentek Series Electronic Manual page 60

SECTION 8: Pentek Intellidrive
Table 9 - Continued
Menu
Parameter
Settings
Internal
Setpoint
Setpoints
External
Setpoint
Sub Menu Parameter
Motor Phase
Connection
Type
Motor Type
Motor
Service Factor
Amps
Min Frequency
Max
Frequency
Max Sensor
Sensor
Value
Variable Frequency Drives
™
Value
Unit of
Measure
Default Min
PSI 60 PSI 15 PSI
PSI 40 PSI 15 PSI
Unit of
Default Max
Measure
_ 1
– 3 wire 3 wire
– Subm Subm
A 00.0 A 00.0 A
Hz 30 Hz 30 Hz
1 above
Hz 60 Hz
Min Hz
PSI 100 PSI 10 PSI
Max
Main pressure setpoint used. Sets
Max
main system operational pressure.
Sensor
This parameter is accessed here,
Value
through PSI Preset button, or by
minus
pressing Enter button while in
3 PSI.
Constant Pressure operation.
Second pressure setpoint. When
another pressure setting is desired
Max other than Internal Setpoint.
Sensor Additional programming needed in
Value I/O section. Requires an external
minus switch or timer to wired to I1 or
3 PSI. I2 terminals. It is only active
when there is voltage present
I1 terminals
Min
Selects phase of motor to be
operated. An additional sub menu
1 3 will appear, based on phase
selection, to select proper motor
type.
Wire type for 1 phase motor
operation only. Can only access
2 wire
by first setting Motor Phase
parameter to 1 Phase.
Motor type for 3 phase motor
Above operation only. Can only access
Gnd by first setting Motor Phase
parameter to 3 Phase.
Per Service factor amps (max. load) of
drive motor the Drive is operating. Sets
and maximum allowed amps at output
motor of Drive. See Table 8 for values.
1 below Minimum frequency (speed) motor
Max Hz will run.
Maximum frequency (speed)
motor will run. Up to 80Hz is only
80 Hz available on only when Motor
Phase is set to 3 and motor type is
Sub.
Maximum pressure value of
transducer sensor used with Drive.
300 PSI Only change if different transducer
is used with Drive, other than 100
PSI max scale.
Description
Description
59