Replacing The Burner Nozzles; Adjusting Or Replacing Bypass Nozzles - Bosch HSV 745055 A Installation Instructions Manual

Note
Replacing the
burner nozzles
Adjusting or
replacing bypass
nozzles
Preparation
18
4. The gas pressure regulator supplied with the
appliance must be installed in line with the gas
pipe (NG only).
5.
Carry out a leak test, see the "Leak test" section.
Open the locking device for the gas connection.
d
Observe the country specific requirements.
1.
Turn all control knobs on the control panel to Off.
2.
Close the locking device for the gas connection.
3.
Remove the pan support and gas burner parts.
4.
Remove the burner nozzles using socket
wrench SW7.
5.
Find the burner nozzles in the table, see the
"Technical data - Gas" section. Insert the new
nozzles into the appropriate gas burners in the
hobs.
Carry out a leak test after this replacement, see the
"Leak test" section.
The bypass nozzles are used to adjust the small flame
in the burners.
Close the gas connection locking device.