Connection - Bosch HSV 745055 A Installation Instructions Manual

Connection

Electrical
Gas
An electrical 16 amp socket needs to be within 1,20 m
of the cooker to allow electrical connection. The
socket must remain accessible after installation of the
appliance.
Important note:
This appliance is connected to the mains (230 VAC)
by means of the connecting lead which must be fixed
to the kitchen unit to prevent it from coming into
contact with hot parts of the cooker. When making
this connection make sure that the lead connot come
into contact with hot parts of the cooker.
Important: This appliance must be earthed.
During the planning stage, consider the position of
supply connections.
The cooker must be connected to the gas supply with
upstream connection of an isolation valve in
accordance with the respectively valid regulations. We
recommend that the isolation valve be fitted prior to
the cooker to enable isolation of cooker from gas
supply. The valve must be easily accessible at all
times.
To find out the factory set gas type, see rear of cooker
next to gas connection.
Remove plastic cap from gas supply line prior to
installation.
Fit regulator (NG) to the R1/2" connection as per
figure.
Direction of gas flow is indicated on the rear of the
regulator. Use pipe compound or thread sealant,
properly threaded pipes and careful assembly
procedure so that there is no cross threading, etc.,
which might cause damage or leakage. Make sure
that all connections performed are free of leakage.
11