Table of Contents
Advertisement
WARNING TO THE
INSTALLER
INSTALLATION WITH A
HOSE ASSEMBLY
Wall fixing
12
Only install with a hose assembly that complies with
AS/NZS 1869 (AGA Approved), 10mm ID, class B or
D, no more than 1.2 m long and in accordance with
AS5601. Ensure that the hose does not contact the
hot surfaces of the hotplate or an oven, dishwasher or
other appliance that may be installed next to the
cooker.
:
WARNING
Ensure that the hose assembly is
restrained from accidental contact with the flue or flue
outlet of an underbench oven.
The hose should not be subjected to abrasion, kinking
or permanent deformation and should be able to be
inspected along its entire length. Unions compatible
with the hose fittings must be used and connections
tested for gas leaks.
Before Leaving Check all connections for gas leaks
with soap and water. DO NOT use a naked flame for
detecting leaks. Ignite all burners both individually and
separately to ensure correct operation of gas valves,
burners and ignition. Turn gas taps to low flame
position and observe stability of the flame for each
burner individually and all together. When satisfied
with the hotplate, please instruct the user on the
correct method of operation. In case the appliance
fails to operate correctly after all checks have been
carried out, refer to the authorised service provider in
your area.
It should be expressly noted that we cannot accept
any liability for direct of indirect damage caused by
wrong connection, leakage or improper installation.
When being repaired, the appliance must always be
disconnected from the mains supply; if required, notify
our customer service.
To prevent the cooker from tipping over, you must fix
the hook supplied to the wall and connect the chain
attached to the rear of the cooker to the hook.
Hide quick links:
Advertisement
Table of Contents
