Control Function Test - Speed Queen FLW1525C Installation & Operation Manual

Installation
Supply Injection System
Number of liquid supply connections
(1–Detergent and 2–Softener)
Liquid supply connection size,
in. (mm)
WARNING
Wear eye and hand protection when
handling chemicals; always avoid direct
contact with raw chemicals. Read the
manufacturer's directions for accidental
contact before handling chemicals. Ensure
an eye-rinse facility and an emergency
shower are within easy reach. Check at
regular intervals for chemical leaks.
1
1 Injection Point
2 Nozzle
3 Supply Dispenser Pump Outlet
Figure 12
14
2
3/8 (9.52)
or
1/4 (6.35)
SW016
3
2
FLW2116N
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
A junction box on the rear panel houses a terminal
strip which furnishes supply output signals for the
supply injection pumps. Refer to Figure 13 for the
injection interface label.
CHEMICAL INJECTION
ELECTRICAL INTERFACE
SOFTENER
DISPENSER
CONNECTION
DETERGENT
DISPENSER
CONNECTION
NO CONNECTION
TERMINAL
BLOCK
NOTE: Normally Open Contacts.
Contacts Close to Start Chemical Injection.
Maximum Load Connection per Contact:
1A @ 120VAC/240VAC
Figure 13
These terminals may be used to provide signals to the
supply injection system but must not be used to
provide power to the actual pump.
Any injection system pump which requires
110 VAC must be powered by a separate external
power source.

Control Function Test

The washer should be cleaned after the installation is
complete. A function test should then be executed on
the unloaded machine:
1. Check the power supply for such characteristics
as correct voltage, phase, and cycles to be certain
they are correct for the washer.
2. Open manual shut-off valves to the washer.
3. Apply power to the washer.
YELLOW
SOFTENER
RELAY
YELLOW/BLACK
RED
DETERGENT
RELAY
RED/BLACK
801653R1
FLW2028N
802733