DIGITAL CONTROL INTERFACE
TIME OUT CONTROL
The Time Out feature keeps the pump from running it's programmed speeds for a set duration adjustable
in the menu. The Time Out feature is displayed in hours and minutes (Hrs:Mins). Once Time Out is inished,
the pump will return to its previous mode of operation, the Start/Stop LED will be lit and ready to turn on at
the next scheduled run time.
TO ACCESS THE TIME OUT MENU:
1. Check that the green power LED is on.
2. Press Menu.
3. Use Up or Down arrows to scroll to "Features", then press Select.
4. Press Select to choose "Timeout".
5. Then press Select again to choose "Timeout Duration".
6. Press Select to change the time. The cursor will highlight the minutes column.
7. Press the Left arrow to move cursor to the hours column. Time out can be set from 1 minute to 10 hours.
8. Press Enter to save the setting.
Note: To cancel any changes, press Escape to exit without saving.
9. Press Escape to exit the menu.
QUICK CLEAN
This feature can be used to increase the pump speed for vacuuming, cleaning, adding chemicals, after a
storm for extra skimming capability. Press the Quick Clean button (LED on) and then Start/Stop to start.
When the Quick Clean cycle is over, the pump will resume regular schedules and be in "Running Schedule"
mode.
QUICK CLEAN (CONT.)
1. Check that the green power LED is on and the pump is stopped.
2. Press Menu.
3. Use Up or Down arrows to scroll to "Features", then press Select.
4. Press the Down arrow and press Select for "Quick Clean".
5. Press Select to choose "Set Speed".
6. Press Select to highlight the "RPM" first (ones) column and change the speed.
7. Use Up or Down arrows to change the speed.
8. Press Enter to save the speed.
9. Press the Down arrow again, and press Select for "Time Duration".
10. Press Select to change the time. The cursor will highlight the minutes column.
11. Use Up or Down arrows to change the time from 1 minute to 10 hours.
12. Press Enter to save the time.
13. Press Escape to exit the menu.
12