Set Speeds 1-8 In Schedule Mode - Xtreme Power 75021 Owner's Manual And Safety Instructions

DIGITAL CONTROL INTERFACE
SET SPEEDS IN EGG-TIMER MODE (SPEEDS 1-4 ONLY)
1. Press Menu.
2. Use Up or Down arrows to scroll to "Speed 1-8", then press Select.
3. Use Up or Down arrow to find the speed (1-4) you wish to program, then press Select.
4. Use the Up or Down arrows to scroll to "EggTimer", then press Select.
5. To set a speed in Egg-Timer mode, press the Down arrow ("Set Speed" will display) and press
Select to change. Use the Up or Down arrow to adjust speed.
6. Press Enter to save the new speed setting.
7. Now press the Down arrow ("Set Time" will display) and press Select to change. Use the Up or Down
arrows to adjust the time.
8. Press Enter to save the new time setting.

SET SPEEDS 1-8 IN SCHEDULE MODE

In Schedule mode, Speeds 1-8 can be programmed to run a certain speed at a certain time of day. To run
a scheduled speed, press Start/Stop. The screen will display "Running Schedules" when it is ready to run
a scheduled speed. If Start/Stop is pressed while a scheduled speed is running, the pump will stop running
the scheduled speed. The pump will not continue to run the scheduled speed until the Start/Stop button is
pressed again.
1. Press Menu.
2. Use Up or Down arrows to scroll to "Speed 1-8", then press Select.
3. Use Up or Down arrows and press Select for the speed you wish to set and schedule.
4. Press Select (display will be highlighted) and scroll to "Schedule".
5. Press Enter.
6. Press Down arrow ("Set Speed" will display) and press Select to change. Use the Up or Down arrow to
adjust speed.
7. Press Enter to save the new speed.
8. Press the Down arrow again, "Set Start Time" will display. Press Select - the cursor will highlight the
minute column.
9. Use the Up or Down arrow to change the time and the Left or Right arrow to move cursor from
minutes to hours.
10. Press Enter to save the new start time setting.
11. Press Down arrow - "Set Stop Time" will display. Press Select. Repeat Steps 8-9 to set stop time.
12. Press Enter to save the new stop time setting.
13. Press Start/Stop.
The Variable Speed Pump will prime and begin to run the programmed schedule at the specified start time.
When running in Schedule or Egg Timer mode, the countdown time (T 00:01) showing the hours and
minutes remaining is displayed.
Programming Schedule for Constant Run
A speed cannot be programmed with the same start and stop times. To run a speed without stopping, set
the Start time one minute after the stop time. Example: A single speed will run non stop if programmed
with a Start Time of 8:00 AM and a Stop time of 7:59 AM.
NOTE: The pump will not run the scheduled speeds until the Start/Stop button is pressed (LED on) to place
the pump in Schedule mode. Note: When two speeds are scheduled during the same run time the pump
will run the higher RPM Speed regardless of Speed # in use. NOTE: The most recent command, Manual or
Schedule, takes priority regardless of speed number RPM.
11