Set Control Panel Language; Set Temperature Unit; Setting Password - Xtreme Power 75021 Owner's Manual And Safety Instructions

DIGITAL CONTROL INTERFACE

SET CONTROL PANEL LANGUAGE

To access the language menu:
1. Check that the green power LED is on.
2. Press Menu and press Select to select "Settings".
3. Use the Up or Down arrows and scroll to "Device" and press Select.
4. Use the Up or Down arrows to scroll to "Select Language and press Select.
5. Use the Up or Down arrows to choose the desired language.
6. Press Enter to select the control panel language. To cancel any changes, press Escape to exit
without saving.
7. Press Escape to exit.

SET TEMPERATURE UNIT

The default setting is Fahrenheit (°F). The pump can be set to either Celsius (°C) or Fahrenheit (°F).
1. Check that the green power LED is on.
2. Press Menu.
3. Press Select to select "Settings".
4. Use the Up or Down arrows to scroll to "Device" menu item. Press Select.
5. Use Up or Down arrows to scroll to "Temperature Units" and press Select.
6. Use Up or Down arrows to choose Celsius (°C) or Fahrenheit (°F).
7. Press Enter to save. To cancel any changes, press Escape to exit without saving.
8. Press Escape to exit.
SET CONTROL PANEL LANGUAGE
Password Protection
The default setting for password protection is disabled. When this feature is enabled, the pump display
will prompt for the password before allowing access to the control panel and buttons. The entered
password is any combination of four (4) digits.
• The pump can always be stopped by pressing Start/ Stop, even when password protection is enabled.
• Password protection cannot be turned back on with Start/Stop while running in manual mode.
• Pressing Start/Stop when the pump is off will return it back to the Running Cycles Mode
and run at
the next scheduled run time. If the present time is within the scheduled run time, the
pump will run the scheduled speed.
• All functions including programming are disabled in Password Protection Mode.
• Screen will read "Enter Password" if any button other than the Start/Stop button is
pressed
• Key icon displayed in the upper left side of the screen when Password Protection is on.

SETTING PASSWORD

1. Check that the green power LED is on.
2. Press Menu. Press Select to select "Settings".
3. Use the Up or Down arrow to scroll to "Device".
4. Press Select.
5. Press Up or Down arrow to scroll to "Password". The default setting is "Disabled".
6. Press Select.
7. Press Up or Down arrow to change the setting to "Enabled". Press Enter to save.
8. Press the Down arrow. "Password Timeout" will be displayed. The factory default time is 1 minute. This
means the Variable Speed Pump will go into Password Protection mode 1 minute after the last control
panel key is pressed.
9. Press Select to change time setting from 1 minute to 6 hours and press Enter to save.
10. Press the Down arrow and then press Select on "Enter Password" to change the setting.
11. Press the Left or Right arrows to move cursor and press the Up or Down arrow to change the
password number to desired setting.
12. Press Enter to save. To cancel any changes, press Escape to exit without saving.
9