Connecting The Device To The Megaview70 Modulator - Marmitek MEGAVIEW70 User Manual

3. CONNECTING THE DEVICE TO
THE MEGAVIEW70 MODULATOR
Switch off all devices before you start connecting. Then connect the device you want to
connect (for instance the DVD-player or AV-camera) to the MegaView70. You can connect
the device with a SCART cable or a cinch cable. Use one of the two possibilities mentioned
below.
Connecting an A/V appliance via SCART (1)
You can use the 'SCART connection' on the modulator to add the video- and audio signal
desired to the antenna signal. You can use a SCART cable (not included) and you connect this
to the 'A/V IN' of the MegaView70.
Tip: See chapter 8 Extra options for the possibility to connect multiple devices
Connecting an A/V appliance via cinch cable and scart adapter(1)
Any so called composite video- and audio signal can be connected to the modulator. For
this you can use the cinch cable and scart adapter (included). Make sure the colours of the
plugs and the sockets are corresponding. That means red to red, white to white and yellow
to yellow.
A/V appliance via SCART to TV (2)
The 'A/V OUT' connection on your MegaView70 offers you the possibility to connect not only
the signal of your A/V devices to the antenna signal, but to also loop it to a TV set via SCART
(for watching devices via the SCART-input instead of via the TV tuner).
Attention: This connection only transfers the A/V signal of the connected device back to the
TV set and not the other TV channels.
Megaview70™ 5