Honeywell 2MLF-DV4S User Manual page 41

Perform the following steps to configure I/O parameters.
Step
1
On the Project Window of SoftMaster, click I/O Parameters.
The I/O Parameter Setting window is displayed.
2
On the I/O Parameters Setting window, click the module area of the
concerned slot to select the applicable module.
Click the arrow button on the Module cell, to display the modules. Select the
applicable module.
3
Double-click the 2MLF-DC4S module.
The module's I/O Parameter Settings window is displayed.
4
Set the Rate control setting to Enable.
5
Set the Increase limit value and the Decrease limit value.
6
When the rate control is set, the analog output value is as shown in the
following figure.
R200 Isolated Analog Output Module 2MLF-DV4S, 2MLF-DC4S User's Guide
September 2010
Action
Honeywell
2. Specifications
2.5. Additional functions
41