Lcd Readout; Arc Parameter Chart - Weldclass WeldForce WF-201T AC/DC Operating Instructions Manual

3.4 LCD Readout

29. Percentage Setting Indicator Light (%)
30. Hertz/Frequency Setting Indicator Light (Hz)
31. Time/Seconds Setting Indicator Light (SEC)
32. LCD Screen
33. Amperage Setting Indicator Light (AMPS)
34. Hot Start Setting Indicator Light (HOT START)
35. Arc Force Setting Indicator Light (ARC FORCE)
29
30
31
Figure 4

3.5 Arc Parameter Chart

36. Pre-Gas Setting Indicator Light (PRE GAS)
37. Start Amps Setting Indicator Light (START AMPS)
38. Slope-Up Setting Indicator Light (UP SLOPE)
39. Trough Amps Setting Indicator Light (TROUGH AMPS)
40. Pulse Wave Frequency Setting Indicator Light (FREQUENCY)
41. Pulse Wave Width Setting Indicator Light (WIDTH)
42. Base/Peak Amp Setting Indicator Light (BASE/PEAK AMP)
43. AC Arc Balance Setting Indicator Light (AC BALANCE)
44. Slope-Down Setting Indicator Light (DOWN SLOPE)
45. Finish Amps Setting Indicator Light (FINISH AMPS)
46. Post-Gas Setting Indicator Light (POST GAS)
38
37
36
Figure 5
10
32
39 40 41
© Weldclass 2019 | E.&O.E.
42
43
.
33
34
35
44
45
46