Getting Information From The Picker's Led - Spectra Logic 2K User Manual

Getting Information from the Picker's LED

The robotic picker's light-emitting diode (LED), visible through the window of the
library, shines either green or amber. The colored light indicates the status of the
picker. The following table describes the LED operational modes and the information
conveyed by these operating modes.
Mode
Green
Green and Blinking
Amber
Amber and Blinking
Blinking Amber and Green
Chapter 4. Using the Library
Information
The picker is idle and the library is ready for use; this is the normal operating mode.
The picker is active and functioning properly.
The library is not ready for use.
Verify that the door is shut and that the library SCSI connection is terminated and is within
specifications; see Appendix B. SCSI Cable and Terminator Requirements.
Failure. For example; to indicate a jam condition. Locate the source of the jam to return
the picker to its normal state.
The library configuration switch has been changed since the last power-up and the library
is changing its configuration (as explained in Chapter 3. Configuring the Library).
40