Jeep Compass Operating Information Manual page 209

1. Remove the scissors jack and lug wrench
from the spare wheel as an assembly. Turn the
jack screw to the left to loosen the lug wrench
and remove the wrench from the jack assembly.
NOTE:
The jack handle attaches to the side of the
jack with two attachment points. When the
jack is partially expanded, the tension be-
tween the two attachment points holds the
jack handle in place.
Removing Jack Handle From Jack
2. Loosen, but do not remove, the wheel nuts
by turning them to the left one turn while the
wheel is still on the ground.
NOTE:
There are front and rear jacking locations on
each side of the body. The front locations
are outlined by two triangular cutouts on
one of the flanges in the sill flange assem-
bly. The rear location is the same but with
two rectangular cutouts. For vehicles
equipped with plastic trim, the plastic has
been cut away to expose the jacking loca-
tions in the body.
Jacking Locations
CAUTION!
Do not attempt to raise the vehicle by jacking
on locations other than those indicated.
Front Jacking Location
205