Fittings - Mamas & Papas Amelia Instructions For Use Manual

FITTINGS

F1 / Long assembly screws x 4
F3 / Barrel nuts x 4
Step 1
Attach the head (C1) and foot
(C3) end to the fixed side (C2).
Ensure the ends are the correct
way around (see page 3).
Slot four barrel nuts into the
holes in the underside of the
fixed sides top and bottom
rails. Ensure the slotted heads
of the barrel nuts face out of
the rails.
Slot four long assembly screws
(F1) through the top and
bottom holes in both of the
cot ends. Slot the screws into
the holes in the ends of the
sides rails and tighten them
into the barrel nuts (F3) using
the allen key (F10).
FITTINGS
F4 / Base brackets x 4
Step 2
Please note: The base
brackets (F4) come in left
(x2) and right (x2) hand
versions.
Slot the unthreaded ends of
the four base brackets into
one of the three base heights
that you require.
Ensure they are all at the
same height.
See the 'instructions for safe
use' for more information on
base heights.
Note: After fitting, the
threaded ends must be
facing upwards.
F1
C1
– 4 –
C2
F3
C3
F4
F4
F1