Safety
Safety Instructions
In order to prevent, electrical shocks, injuries,
and the risk of fire the following basic safety
instructions should be followed.
Use ear protectors
When working with various materials, the sound
level may vary and at times exceed the 85 dB (A)
limit. Always use ear protectors to protect yourself.
Use safety goggles
Always use safety goggles to prevent injury to your
eyes from particles thrown up when using the pipe
saw.
Use safety gloves
Always use safety gloves as the edges of cut pipes
are sharp and can cause cuts.
Keep the work area tidy
An untidy work area can be hazardous and may
cause an accident.
Pay attention to where you are working
Do not take the pipe saw out in the rain. Never use
it in wet or damp areas. Ensure that the working
area is well lit. Never use the pipe saw near
flammable liquids or gases. If the pipe saw does
get left out in the rain or gets wet in some other way,
have it serviced by an approved service agency.
Protect yourself from electrical shocks
Avoid coming into contact with objects that conduct
electricity, such as pipe systems, heating radiators,
cookers, washing machines, and refrigerators.
Keep the pipe saw away from children
Keep children away from the pipe saw and its
extension cable. Children under 16 years old must
be supervised.
Store the pipe saw correctly
Always store the pipe saw with the motor unit in the
upright position. When you are not using the pipe
saw, keep it in a dry place. Ensure that the storage
place is locked and high enough to be out of the
reach of children.
Do not overload the pipe saw
Using too great a cutting force or too high a pipe-
cutting speed can overload the machine. Always
arrange sawing so that when you cut through the pipe
it cannot close in on the sawn gap and clamp onto
the blade. The machine works at its best and safest
when it is used the way for which it was designed.
Dress suitably
Do not use clothing that is too loose or jewellery
when using the pipe saw as they could get caught
on moving parts of the machine. When working
outdoors use rubber gloves and non-slip shoes. If
you have long hair, use a hairnet.
Ensure that your work environment is safe
Ensure that no one else is working close to you and
that there are no objects that could be damaged by
your work.
Do not damage the power cable
Never carry the pipe saw by its power cable. Do not
pull the plug from the socket by pulling on the cable.
Protect the power cable from heat, oil, and sharp
edges.
Attach the pipe saw correctly
Always ensure that the gripper unit on the pipe saw
is firmly attached on the pipe that is going to be
sawn.
Do not stoop over your work
Always stand maintaining a firm steady stance when
using the pipe saw.
Take proper care of the pipe saw
Keep the pipe saw clean and only use sharp blades.
Always follow the servicing instructions and the
instructions for changing the blade. Check the
condition of the power cable regularly and have it
changed by a qualified electrician if necessary. Also
regularly check the condition of the extension cable
you use and replace it if necessary. Keep the pipe
saw's handle dry and clean from oil and grease.
Take the plug out of the socket
Always disconnect the power to the pipe saw by
removing the plug from the socket when the pipe
saw is not in use, when you change the blade, or
when you service it. Always remove the plug from
the socket before removing the blade guard.
Avoid unintentional starting
Never carry the pipe saw with your finger on the
power switch while the saw is connected to its power
supply. Check that the power switch is in the off
position and the motor is in the upright position
before putting the plug into a socket.
5
Need help?
Do you have a question about the PipeCut 360 System and is the answer not in the manual?