KX-TGP500B04/KX-TPA50B04
9 Service Mode
9.1.
How to Clear User Setting
Units are reset to the Factory settings by this operation (Erase stored Phone numbers, Caller list and etc.).
This operation should not be performed for a usual repair.
9.1.1.
Base Unit
Set up Base unit in Test mode through USB. (Refer to USB Test Mode (P.43).)
Step
Test Command
1
ts
2
h (*2)
3
z
: Enter key
9.1.2.
Handset
Note:
(*1) Be sure to short the battery terminals of the handset with a lead wire, etc. for 2 seconds for discharge after removing the
battery.
(*2) Pre-Provisioning data is initialized at h command.
If Pre-Provisioning data is necessary to be kept, use hcar command instead of h command.
Content
Enter test mode
Make sure the Echo back "TEST" after this command.
Clear User Setting
Make sure the Echo back "OK" after this command.
Exit Test Mode
Description
48