Table of Contents
Advertisement
4-1. Teraterm will be activated automatically if disconnect and reconnect a PC and the base unit by a USB cable.
4-2. Select "Serial port" from "Setup" menu.
• Change the settings of "Serial port setup" as follows. Then click OK.
(1) Select "Serial port" from "Setup" menu.
4-3. Select "Save setup" from "Setup" menu and overwrite TERATERM.INI.
Note:
• Once you install USB driver and test mode application, it is unnecessary to do it again.
8.3.2.
How to Start USB Test Mode
Be sure to install the application for test mode before starting. See How to Install the Application for Test Mode (P.43).
<Enter>
1. After PC Setting (P.45), enter "ts " on the window of "Tera term".
2. "TEST" is returned. This state shows Test mode.
<Exit>
1. Enter "z " to finish Test mode.
Note:
• If disconnecting USB cable at Test mode state and connecting it to the unit again, "ts" command needs to be entered before
inputting any commands.
• : Enter key.
(2) Select your port number.
(Refer to " 3-1.Confirm the
USB port number")
47
KX-TGP500B04/KX-TPA50B04
(4) Click "OK".
(3) Set these items like this.
Hide quick links:
Advertisement
Table of Contents
