Panasonic KX-TGP500B04 Service Manual page 26

KX-TGP500B04/KX-TPA50B04
8.1.3. RX-CW Test Mode for Base Unit
Set up Base unit in Test mode through USB. (Refer to USB Test Mode (P.43).)
Step Test Command
1
ts
2
b0
3
saX
4
pX
5 b4 XX
6
b0
7
z
Note:
: Enter key.
: Space key.
(*1) Refer to Check Table for RF part (P.73) for proper Handset settings.
8.1.4. Test Link Mode for Base Unit
"For test link only, No voice."
Set up Base unit in Test mode through USB. (Refer to USB Test Mode (P.43).)
Step Test Command
1
ts
2
saX
3
pX
4
c XX
5
a3e 2
6
pd
7
8
srX
9
rsi
10
11
b0
12
z
Note:
: Enter key.
: Space key.
(*1) Refer to Test Link Mode for Handset (P.30). If can not proceed to the next step, refer to Registering a handset to the base
unit in the Operating Instructions.
(*2) Refer to Check Table for RF part (P.73) and Test Link Mode for Handset (P.30) for proper Handset settings.
(*3) Refer to Frequency Table (P.93).
Content
Enter test mode
End the BER mode
Antenna setting
TX power setting
RX-CW Mode (*1)
End the BER mode
Exit Test Mode
Content
Enter test mode
Antenna setting
TX power setting
Channel setting
Test link Enable
Start dummy bearer
Turn to Test Link Mode (*2)
RX Gain level setting
Get current RSSI value
Exit Test Link Mode
End the BER mode
Exit Test Mode
Description
Make sure the Echo back "TEST" after this command.
X = antenna setting
0=Auto select, 1= Antenna 1, 2= Antenna 2
X = TX power level
1=Low power, 2=High power
XX = channel setting
00 - 04 (HEX)
Description
Make sure the Echo back "TEST" after this command.
X = antenna setting
0=Auto select, 1= Antenna 1, 2= Antenna 2
X = TX power level
1=Low power, 2=High power
XX = channel setting (*3)
00 - 04 (HEX)
Link Standby mode
Set the Handset to "Test Link Mode" (*1) beside the Base Unit, then
the base unit turns to "Test Link Mode" .
X = RX gain level
0=High gain, 3=Low gain
Press OFF key of the handset.
26