Test Mode; Adjustment And Test Mode Flow Chart - Panasonic KX-TGP500B04 Service Manual

8 Test Mode

8.1.

Adjustment and Test Mode Flow Chart

8.1.1. Test Burst Mode for Base Unit
Set up Base unit in Test mode through USB. (Refer to USB Test Mode (P.43).)
Step Test Command
1
ts
2
b0
3
saX
4
pX
5 b5 XX ++++
6
b0
7
z
Note:
: Enter key.
: Space key.
(*1) Refer to Check Table for RF part (P.73) and RX-CW Test Mode for Handset (P.29) for proper Handset settings.
8.1.2. TX-CW Test Mode for Base Unit
Set up Base unit in Test mode through USB. (Refer to USB Test Mode (P.43).)
Step Test Command
1
ts
2
b0
3
saX
4
pX
5 b3 XX
6
b0
7
z
Note:
: Enter key.
: Space key.
(*1) Refer to Check Table for RF part (P.73) and RX-CW Test Mode for Handset (P.29) for proper Handset settings.
Content
Enter test mode
End the BER mode
Antenna setting
TX power setting
Test Burst Mode (*1)
End the BER mode
Exit Test Mode
Content
Enter test mode
End the BER mode
Antenna setting
TX power setting
TX-CW Mode (*1)
End the BER mode
Exit Test Mode
Description
Make sure the Echo back "TEST" after this command.
X = antenna setting
0=Auto select, 1= Antenna 1, 2= Antenna 2
X = TX power level
1=Low power, 2=High power
XX = channel setting
00 - 04 (HEX)
++++ = slot setting 0100=full slot
++++ = slot setting 0001=long slot
Description
Make sure the Echo back "TEST" after this command.
X = antenna setting
0=Auto select, 1= Antenna 1, 2= Antenna 2
X = TX power level
1=Low power, 2=High power
XX = channel setting
00 - 04 (HEX)
25
KX-TGP500B04/KX-TPA50B04