Deliming - Vulcan-Hart C24EA Series Service Manual

C24EA SERIES ELECTRIC CONVECTION STEAMERS - STEAM GENERATOR
Fig. 74
12. Remove low voltage control box from steamer.
A. Disconnect wiring harness connector
leading to cooking compartment controls.
Fig. 75
B. Disconnect delime valve and drain valve
harness connectors from control board.
C. Remove four bolts securing low voltage
control box to frame.
Fig. 76
13. Remove WATER LEVEL PROBES.
14. Remove ground wire from water level probe
housing.
15. Remove hardware securing steam generator to
frame (four places) then remove generator.
F35453 Rev. A (0119)
16. Remove the following parts from steam
generator for reuse:
A. Drip shield (above elements).
B. Remaining pipe nipples, tees and elbows.
17. If removed or replacing steam generator, install
insulation around the generator. Secure into
position using high temperature aluminum foil
tape.
18. Reinstall parts removed in reverse order. Apply
pipe thread sealant to all pipe threads connected
to the steam generator.
19. Check steamer for proper operation. Inspect all
connections for leaks.
Refer to the INSTALLATION AND OPERATION
manual under the Maintenance section for specific
instructions.
Page 52 of 75

DELIMING