Vulcan-Hart C24EA Series Service Manual page 14

Fig. 20
D. Open door.
2. Remove striker.
3. Remove any burrs on striker that may cause latch
to stick.
4. Apply Loctite 271 to threads of striker.
5. Reinstall striker with slotted side up. Snug striker
nut. Perform Adjustment, so door will not jam.
Adjustment
1. Reinstall striker with slot pointing upward and
hand tighten nut only.
2. Close door to center striker in front panel
mounting hole.
3. Open door and check striker slot for horizontal
alignment. The slot on striker must be kept
horizontal in order for door latch to catch properly
and latch.
4. Once proper slot alignment has been set, hold
striker close to its base then tighten the striker
nut. Be careful not to damage striker slot when
tightening or door may not latch properly.
NOTE: Do not over-tighten nut. If over-tightened,
striker may turn and change alignment.
NOTE: If door does not open easily, add shims
between striker and cabinet front. When adding shims
make certain that door gasket seals properly and
steamer does not leak. Remove shims as necessary
until leaking stops.
F35453 Rev. A (0119)
C24EA SERIES ELECTRIC CONVECTION STEAMERS - DOOR
Page 14 of 75