Yanmar YM276 Service Manual page 447

FRONT AXLE ASSEMLY
80.05-1
Removal and installation of both 2-wheel and 4-wheel drive front
axle assemblies are covered in this Section. Inspection and
replacement bushings and bearings and repair of king pin assembly
on 2-wheel drive front axle are also provided. For inspection
and repair of 4-wheel drive front axle, see Chapter 50, Section 40.
2-WHEEL DRIVE FRONT AXLE REMOVAL
1. Set parking brake and block rear wheels.
2. Attach a hoist or jack t o bumper, lift up tractor just enough
t o take weight off tires.
CAUTION: Do not l i f t so high that the tractor tip over for
A
slipping wt of block or jack head.
f l
3. Disconnect drag rod (A) from steeringarm (B).
A
-
Drag Rod
B
-
Stwring Arm
4. Remove four cap screws (A) from center pin (0).
5. Place floor jack under center of axle.
6. Carefully pull the center pin out.
v
Do not lome or damage adjusting shims behind the square
plate of center pin.
7.
Raise front of tractor with the hoist or jack and roll front
axle away.
A --Cap Screw.
6
-
Canfar Pin