Yanmar YM276 Service Manual page 204

CHARGING CIRCUIT (35Aj
40-1 1-1
ALTERNATOR
See Chapter 240, Section
10
for charging circuit diagnosis and
operation.
REMOVAL
1.
Disconnect battery ground cable a t negative I-) battery
terminal.
2.
Remove three screws and remove belt cover (D).
3. Disconnect harness connector ( 0 ) and terminal wire (C) and
ground wire.
4. Support alternator and remove two mounting bolts (Al and
adjusting screw IF). Lift o f f alternator and belt guard (El.
A -Mounting BolO
D -Belt Cover
B -Ha-
Connestor
E
-
8alt Guard
C
-Terminal
W i n
F
-
Adjusting Suaw
DISASSEMBLY
1.
Remove three thru bolts
2.
Using two screwdrivers, separate drive end-housing from stator.
Do not pry against stator wires.
%311
SME2760/114+304 YM276and 276D
Xinornoto, Printed in Japan