Yanmar YM276 Service Manual page 358

Front Wheel Drive
50-40-7
-
INSPECTION
1.
lnspect all gears for uneven wear, chips, scoring and cracks
and replace as necessary.
2. lnspect all bear~ngs f o r wear and damage and replace as neces-
sary.
3.
Measure thickness o f spacer.
Item
New Part
Wear Limit
. . . . . .
Thickness
. . . . . . . . . . . . .
4.9 to 5.0
mm
4.7
mm
10.193 to0.197 in.) 10.185 in.)
4. Remove snap ring and washer t o remove needle bearings and
collar o n spindle.
5. lnspect spindle shaft, especially needle bearing surface for wear
or scoring.
Item New Part
0.D. at Needle Bearing.
. . . . . . . . . . . .
27.99 to 28.00 rnm
11.1020 to 1.1024 in.)
6. Inspect key for wear o r damage.
Width Key Way
. . . . . . . . . . . . . . . . .
7.0010 7.02 mrn
10.275
to
0.276 in.)
7. Assembly key, arm and spindle and check if there was play o r
not. Replace itlthem if required.
p00c07
SME27601718304 VM276 snd
2760
Kinomaro. Printed in Japan